APP
MODULE Documentation
40 BAB TECHNOLOGIE GmbH
5.3.7
CONFIGURATION EXAMPLE FOR ENOCEAN PUSH-
BUTTON (ROCKER)
In the following, an exemplary configuration for sending and receiving of an EnOcean push-button
(Rocker) profile (profile "
05-02-01: 2Rockers, Light & Blind
") is shown.
APPMODULE AS THE RECEIVER (ACTUATOR)
This switch provides either one or two rockers and transmits their status within a radio signal. In order to
link these radio signals with KNX, various functions are available:
Configuring Parameters:
Invert:
Inverts the
telegram content sent
on the KNX addresses.
Telegram value “1”
becomes “0” and vice
versa.
Individual Timings:
Individual timings
determine the length of
button presses for
switch, move, step.
Separate Action:
You
can assign further KNX
addresses for the
separate action “both
rockers at the same
time”.
Please note that
this is only possible for
buttons with two
rockers.
Assigning Addresses:
Switching / Dimming:
The EnOcean button can
be used as switch and
dimmer. A long-press
will be interpreted as a
dimming command.
When used as a switch,
the button will send a 0
on “Off” and a 1 on
“On”.
Push Button:
Pressing
“Off” will send an EIS 1
telegram with value 0.
Upon releasing the
button, another
telegram with value 1
will be sent. Pressing “On” will
send an EIS 1 telegram with value 1. Upon releasing the button, another telegram with value 0
will be be sent. You can assign one address for either position (I and O).
Blind:
Assign one address each for the commands “Move” and “Step” (EIS 1).
Figure 32: Receiving KNX parameters
