B.Pro B.PROTHERM BPT 1020 EUK, Перевод оригинальной инструкции по эксплуатации, Страница: 11 / 48

B.PROTHERM Stainless-Steel, Cooled
– 7 –
Cleaning and care Power plug
Unplug the power plug before cleaning the unit. Water seeping into the unit
can cause a short-circuit. If this happens, there is a risk of electric shock.
Hygiene
The provisions of the hygiene guidelines 93/43/EEC as well as your national
hygiene regulations must be complied with.
The inner unit body fulfills the requirements of the hygienic design H 1.
Cleaning frequency
Clean the unit thoroughly after each use.
The unit is equipped with an automatic defroster and a condensation-water
catch tray (GN 1/3-40).
Empty the condensation-water catch tray daily to avoid overflowing and the
related danger of slipping or of damage to the floor.
Cleaning methods
Use only approved cleaning methods.
Do not use a steam jet device or high-pressure cleaner.
Cleaning agent for synthetic parts
Do not use scouring agents. Scouring agents scratch the surface.
Do not use the following cleaning agents or cleaning agents containing the
following substances (damage to material!):

Ethyl alcohol, isopropyl alcohol and higher alcohols

Acetone

Cleaning benzene

Turpentine

Acetic ester
Cleaning water
Thoroughly dry the unit after cleaning. Remove cleaning water from the floor
of the unit interior.
A danger of slipping exists if cleaning water runs out of the unit during or after
cleaning.
Completely wipe up any water which runs out of the unit.
Maintenance Locking brakes
Regularly check the effectiveness of the locking brakes.
If the effectiveness of the brakes is not sufficient, have the defective castor
replaced immediately by one of the following:

In-house, by B.PRO-trained technician

Externally, by B.PRO-trained customer service engineer

B.PRO Service
Unit door
Check the door seal for damage and aging after each cleaning (visual check).
Electrical safety: Re-inspection
At least once every six months, have a periodical electrical safety inspection
carried out by a professional electrician in accordance with the DIN VDE 0702
series of standards.