21
MAG
User Manual v2.0
4.2 CONVERTER POSITIONINIG
4.2.1 Positioning/installation of the converter in COMPACT version
For the correct positioning of the converter in the COMPACT version, refer to the INSTALLATION
manual of the sensors where all correct and incorrect mounting positions are described and
illustrated.
The converter display can be rotated 90 °. Unscrew the front protection cover (see 1, Fig. 14) and remove it.
Locate and pull out the converter display unit (see 2, Fig. 14) by 2 ÷ 3 cm, rotate it 90° in the most appropriate
direction into the new position and insert it again. Put back the front protection cover (see 1, Fig. 14), tighten
firmly to ensure sealing closure.
WARNING! Do not rotate the display unit beyond 90° in order to prevent the cables connected to the
sensor from turning. Also, do not pull out the display unit, otherwise voltage can be transmitted and
damage to the wires connected to the sensor may occur.
The converter can be rotated 90 degrees. Loosen the two screws on the lower part (see 1, Fig. 15) positioned
on the neck of the sensor and rotate the converter up to 90° appropriately. Once the new position is set,
tighten the two screws (see 1, Fig. 15) to secure the converter to the sensor.
WARNING! Avoid exposing the converter to excessive vibrations. Use the remote version in case
vibrations may occur.
0
0
1
.000
.0% 0.0m/s
t+
m3/h
m3
menu
1.6443
>
0
0
0.
0
6.
1
1
3
4
4
s/
m0
.0
%0
.0
u
ne
m
>
+t
h/
3
m
3
m
2
1
1
Fig. 14
90°
1
Fig. 15
