B medical systems MT100, Инструкция по эксплуатации

Страница: 12 / 28

12
3 Installation Procedure
WARNING
• All installation work and adjustments to the device must be carried out by qualified personnel. Work
performed by persons with insufficient technical knowledge may adversely affect the performance or cause
physical injury or damage to the equipment.
• Ensure that the connecting cable is not squeezed or bent when the unit is being installed or moved.
Deterioration of the insulation may cause current leakage or electric shock.
• When transporting or moving the device, be aware of its weight.
3.1 Location
• The following section provides information on how to install and place the device in your location.
WARNING
• Do not use the device outdoors unless the unit is operated in covered places; an external use is only
permitted if the unit is safely protected from rain and dust. Current leakage or electric shock may result if
the unit is exposed to rain water.
• Ensure that the device is steady and perfectly straight and does not knock against anything next to it. If the
floor is not strong enough or the installation site is not adequate, this may result in injury from the unit
falling or tipping over.
• Never install the device where acid or corrosive gases are present as current leakage or electric shock may
result due to corrosion.
• The power supply plug must be easily accessible
• Make sure the ventilation openings are never blocked.
• When the unit is in its final position it is important to immobilise the unit using the brakes.
CAUTION
• Optimal function of the device is given at an ambient temperature and maximum relative humitdity indicated
in the technical data (see chapter 11).
• Ensure that there is sufficient room around the unit for air circulation.
• The device must be set up in a dry well-ventilated place. Avoid direct sunlight or locating it close to a heat
source.
• Do not locate the unit below a ceiling fan or right next to air-conditioning equipment.
• This device cannot be used/is not for use in facilities at altitudes of 2000m or higher.