1/8” Allen Wrench
Torque Wrench
TOOLS
NEEDED:
MR16 LAMP INSTALLATION
2a. Firmly insert proper MR16 lamp into socket to make
connection.
Do not exceed the maximum wattage
listed on the fixture label before installing.
Lamp Installation Or Re-lamping
PAR36/AR111 LAMP INSTALLATION
2b. Install proper PAR36/AR111 lamp by placing
connectors around loosened terminal screws, then
gently tightening screw to make connection.
Do not exceed the maximum wattage listed on
the fixture label before installing.
3. Remove any dirt or debris in o-ring groove near top
of housing. Place o-ring inside of groove.
Failure to clean groove of debris will cause fixture
to fail and void product warranty.
Hot Surface
High Voltage
Warning
Flammable
1. Remove faceplate using a 1/8” allen wrench. If
there is an optional accessory holder, carefully
squeeze tabs on sides and gently pull from slots on
OptiLock.
4. Install faceplate using a 1/8” allen wrench and
hand-tighten the faceplate screws in a star pattern
to 30 in-lbs. min.
Do not use a power tool to install screws. Do not
exceed 40 in-lbs.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
Standard Instructions
HP2
INTEGRAL TRANSFORMER - STANDARD MR16 & PAR36/AR111
RELEASE DATE
08/28/2023
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
REFERENCE NUMBER
INS-2858-00