B+B SmartWorx V3, Руководство по настройке

Страница: 88 / 112

4. CONFIGURATION
4.20 USB Port Configuration
The USB port configuration can be made choosing USB Port option in the menu. Config-
uration can be done, if USB/RS232 converter connected.
Item Description
Baudrate Applied communication speed.
Data Bits Number of data bits.
Parity Control parity bit:
• none – will be sent without parity
•
even – will be sent with even parity
•
odd – will be sent with odd parity
Stop Bits Number of stop bit.
Split Timeout Time to rupture reports. If you receive will identify the gap between
two characters, which is longer than the parameter value in millisec-
onds. Then all of the received data compiled and sent the message.
Protocol Communication protocol:
•
TCP – communication using a linked protocol TCP
• UDP – communication using a unlinked protocol UDP
Mode Mode of connection:
•
TCP server – router will listen to incoming requests about TCP
connection
•
TCP client – router will connect to a TCP server on the speci-
fied IP address and TCP port
Server Address In mode TCP client it is necessary to enter the Server IP address.
TCP Port In both modes of connection it is necessary to specify the TCP port
the router will communicate on.
Inactivity Timeout Time period after which the TCP/UDP connection is interrupted in
case of inactivity
Table 64: USB port configuration 1
If the Reject new connections item is ticked, all other connections are rejected. This means
that it is not possible to establish multiple connections.
79