SmartSwarm 300 Series
:
120
There are nine Tabs: Home; Settings; Troubleshooting; Agents; Hub Client; Cellular; Logs; Debug and Modbus
15.1.1 HOME
From the Home tab, you can see some important information about your SmartSwarm device:
●
Firmware Version
●
Components Version
●
Serial number
●
U-Boot Version
●
Device uptime, connected users, load average
15.1.2 SETTINGS
The Settings tab enables you to configure your connectivity ports:
●
Cellular
●
ETH0
●
ETH1
If you intend to use the Cellular interface for your outbound connection you must enter your APN and network
credentials here.
By default, ETH0 will operate as a LAN interface only and ETH1 will expect to be served an address from a DHCP
server.
We assume that the DHCP server that serves this address will also provide a route to the internet.
If this is not the case, you may need to re-configure your ETH1 interface.
15.1.3 TROUBLESHOOTING
The Troubleshooting tab gives you the ability to see the actual internal device status of a number of key interfaces,
processes and settings.
This interface gives you a drop-down list of commands that you can trigger, so that you can gather some
potentially valuable run-time information. In the case your device is not performing as you think it should.
When you’re working with the Advantech B+B SmartWorx technical support engineer, he may ask you for some of
the details that are available from this Tab.
In most cases, you must select the command from the drop-down list, then hit the ‘
Execute
’ button.
This will execute the command on the device, and feedback the results to the browser window.
