SmartSwarm 300 Series
:
107
11. VERIFY YOUR DATA FLOW
In order to verify your data flow, we recommend that you verify each step below.
Step
What to verify
Reference
1
Verify your physical connection to the Modbus bus.
Section 4.5
Appendix 3
2
Verify that your SmartSwarm device has a secure connection to
SmartWorx Hub.
A secure connection to SmartWorx Hub exists if the USR LED, on the front
panel of the SmartSwarm device, is ON (yellow).
Section 4.3 and 4.4
Section 5.1 to 5.4
Appendix 3
3
Verify that your Modbus interface is configured to the correct settings.
The settings you select must match those of the Modbus Master.
Section 7
Appendix 3
4
Verify that your MQTT interface is configured to the correct settings. The
settings you select must match those of the MQTT broker you wish to
publish to.
We recommend that you use non-secure settings until you have verified
connectivity. Then enable a fully secure connection.
(e.g. Initially, get some test-data published on a public MQTT broker,
without enabling TLS to secure the transport layer.)
Once you have verified your data flow using non-secured sample data, we
recommend that you secure your entire data flow.
Section 8
Appendix 6
5
Verify your Slave enrichment.
Section 9
6
Verify that you have configured the Event Rules correctly. Data will only
be published in accordance with the Event Rules that you have enabled.
Section 10 (Events -
WHEN)
Appendix 3
7
Verify that the data you will publish is the data you intend to publish.
Section 10 (Payloads -
WHAT)
Appendix 3
