1-888-948-2248 |
Europe:
+353 91 792444
advantech-bb.com
707 Dayton Road | PO Box 1040 | Ottawa, IL 61350
Phone: 815-433-5100 | Fax: 815-433-5109
www.advantech-bb.com | E-mail: [email protected]
Fast and easy on the web:
www.advantech-bb.com
QUICK START
GUIDE
Document Number: 710-10225-00_R3_ABDN-SE-DP55x_1017qsg
Recommended Accessories
Before you begin, be
sure you have the following:
ABDN-SE-DP551 &
ABDN-SE-DP553
Wireless Serial Adapter
+ ABDN-SE-DP551 or ABDN-SE-DP553
+ 5 VDC Power Supply, 2.1 mm barrel jack
(included)
+ Dual Band 2dBi RP-SMA Antenna
(included)
+ Software CD (included)
Null Modem Cable
Model 232NM9FF3
802.11 Wireless Router,
Access Point & Serial
Device Server
Model APXN-Q5420
(Continued)
Troubleshooting
5
To Do A Factory Reset:
Apply power while you have the
Reset button held in. Hold the Reset button and release
after 10 seconds.
After Initial Configuration:
If you have an Amber “Power”
LED and a Red “Link” LED combination, please verify that
the SSID and security are correct. These parameters are
case sensitive.
LED
COLOR
AIRBORNE DEVICE STATE
POWER
Off
Adapter is not powered.
Red
Adapter failed Power On Self Test (POST).
Amber
Adapter passed POST but is not configured for wireless network
communication.
Green
Adapter passed POST and is configured for wireless communica
-
tion.
LINK
Off
Adapter is not powered.
Red
Off
(Periodic Blinking) Adapter is searching for a valid network (Access
Point) that matches device’s configuration.
Green
Adapter has successfully associated with an Access Point.
COMM
Off
If Power LED is also Off, then Adapter is not powered.
If Power LED is On, then either:
• A physical connection detected on Serial/Ethernet cable.
• No TCP session from wireless interface has been established.
Red
No physical Serial/Ethernet connection has been detected.
Red
Off
(Blinking – OFF/Red) A physical Serial/Ethernet connection has
been detected and there is traffic across the interface.
No TCP connection to the adapter has been established on the
wireless interface.
Amber
A TCP connection to the adapter from the wireless interface has
been established but no physical connection on the Serial/Ethernet
interface has been detected.
Green Amber
(Blinking – Green/Orange)
A physical Serial/Ethernet connection has been detected and there
is Serial/Ethernet traffic across the interface. A TCP connection to
the adapter has been established (On WLAN or Ethernet interface).
Green
A physical Serial/Ethernet connection has been detected. A TCP
connection to the adapter has been established from the WLAN or
Ethernet interface but no traffic has been detected.
If you have questions, visit our Knowledge Base at
www.advantech-bb.com
CLI commands let you request status or change
parameter settings. A full list of commands is
provided on your software CD. You can also
download this information at
www.advantech-bb.com
Please see the Knowledge Base on the B+B SmartWorx
website if you run into any issues while trying to follow
this guide.
