Recommended Accessories
Industrial DIN Rail
Power Supply
Model# MDR-20-24
RS-232 3-Stage
Surge Protector
Model# 232HESP
Document Number – 710-10579-00_r1_232OPDRi_0618qsg
1 (888) 948-2248 |
Europe:
+353 91 792444
www.advantech-bb.com
707 Dayton Road | PO Box 1040 | Ottawa, IL 61350
Phone: (815) 433-5100 | Fax: (815) 433-5109
www.advantech-bb.com | E-mail: [email protected]
Before you begin, be
sure you have the following:
Model 232OPDRI
RS-232 Repeater with 3-Way Isolation
Fast and easy on the web:
www.advantech-bb.com
+ 232OPDRI Isolated Repeater
+ Required but not included:
- 10 to 48 VDC Power Supply
- Two RS-232 Cables
- Ground Cable
QUICK START
GUIDE
Troubleshooting
4
Are My Devices Wired As DTE or DCE?
How to check:
1. Use Rule of Thumb
- If the device plugs into the
computer serial port and works normally, the
device is wired as DCE (or the connection cable is
a crossover type that makes it work as a DCE).
If the device connects to the computer port using a
“null modem” crossover cable, it is wired as DTE.
2. Use RS-232 Line Tester
- A quick and easy way
to determine the DTE/DCE port type is to use an
RS-232 line tester such as the 9PMTT. The tester
can show the signal state of any active RS-232 data
lines using LEDs lighting Red or Green. Active data
lines are output from a device. They may be either
High or Low.
POWER, INPUT AND OUTPUT (I/O) WIRING
MUST BE IN ACCORDANCE WITH CLASS
I, DIVISION 2 WIRING METHODS [ARTICLE
501.10(B) OF THE NATIONAL ELECTRICAL
CODE, NFPA 70] AND IN ACCORDANCE WITH
THE AUTHORITY HAVING JURISDICTION.
WARNING – EXPLOSION HAZARD –
SUBSTITUTION OF COMPONENTS MAY IMPAIR
SUITABILITY FOR CLASS I, DIVISION 2.
ATTENTION - DANGER D’EXPLOSION - LA
SUBSTITUTION DE COMPOSANTS PEUT
ENTRAÎNER UNE ADÉQUATION À LA CLASSE I,
DIVISION 2.
WARNING – EXPLOSION HAZARD – WHEN IN
HAZARDOUS LOCATIONS, TURN OFF POWER
BEFORE REPLACING OR WIRING MODULES.
5
UL Class1/Division 2
Warning Information
ATTENTION - DANGER D’EXPLOSION -
LORSQU’IL EST DANS DES ENDROITS
DANGEREUX, COUPER L’ALIMENTATION AVANT
DE REMPLACER OU DE RACCORDER LES
MODULES.
WARNING – EXPLOSION HAZARD – DO NOT
DISCONNECT EQUIPMENT UNLESS POWER
HAS BEEN SWITCHED OFF OR THE AREA IS
KNOWN TO BE NONHAZARDOUS.
ATTENTION - DANGER D’EXPLOSION - NE PAS
DÉCONNECTER L’ÉQUIPEMENT PENDANT
QUE LE CIRCUIT EST VIVANT OU À MOINS
QUE LA ZONE NE SAIT ÊTRE EXEMPTE DE
CONCENTRATIONS IGNIFIABLES.
