B+B SMARTWORK SPECTRE V3, Руководство по настройке

Страница: 98 / 136

4. CONFIGURATION
4.20 Expansion Port Configuration
Configuration of the expansion port can be done via Expansion Port 1 or Expansion Port 2
items in the menu.
•
If the router has the RS232 interface, you configure it with the Expansion Port 1 selection.
( Expansion Port 2 is not used).
•
If the router has the RS485/422-232 interface, you will configure the RS232 interface
with the Expansion Port 1 selection, and the RS485/422 interface with the Expansion
Port 2
selection.
• If the router has the RS232-485-ETH interface, you will configure the RS232 interface
with the
Expansion Port 1
selection, the RS485/422 interface with the
Expansion Port 2
selection and the ETH interface with the LAN selection (the Tertiary LAN subpage).
•
If you have the SWITCH version of the router (3x Ethernet, ETH2 interface), the port can
be configured in the LAN item on the Tertiary LAN subpage – see Chapter 4.1 .
In the upper part of the configuration window, the port can be enabled and the type of the
connected port is shown in the
Port Type
item. Other items are described in the table below:
Item Description
Baudrate Applied communication speed.
Data Bits Number of data bits.
Parity Control parity bit:
•
none – data will be sent without parity.
•
even – data will be sent with even parity.
• odd – data will be sent with odd parity.
Stop Bits Number of stop bits.
Split Timeout Time to rupture reports. If the gap between two characters exceeds
the parameter in milliseconds, any buffered characters will be sent
over the Ethernet port.
Protocol Protocol:
• TCP – communication using a linked protocol TCP.
•
UDP – communication using a unlinked protocol UDP.
Continued on next page
89