B+B SMARTWORK SmartMotion, Руководство по настройке

Страница: 49 / 144

4. CONFIGURATION
4.4.6 Switch between SIM Cards Configuration
In the bottom part of the 1st (2nd) Mobile WAN Configuration page you can specify the
rules for toggling between the two SIM cards.
The router will automatically toggle between the SIM cards and their setups depending on the
configuration here (manual permission, roaming, data limit, binary inputs state). Note that the
SIM card selected for connection establishment is the result of the logical product (AND) of
the configuration here (table below).
Item Description
Enabled Enable or disable the SIM card usage. If you set all the SIM cards
to
no (disabled), it means the cellular module is disabled.
•
yes – It is possible to use the SIM card.
• no – Never use the SIM card, the usage of the SIM is for-
bidden.
Roaming Configure usage of SIM cards based on roaming. The roaming
has to be activated on SIM card where enabled!
•
don’t care
– It is possible to use the SIM card everywhere.
• home only – Only use the SIM card if there was no roaming
detected.
Data Limit Configure usage of SIM cards based on Data Limit set above:
• don’t care – It is possible to use the SIM regardless the
limit.
•
not exceeded – Only use the SIM card if the Data Limit (set
above) was not exceeded.
BIN0 Configure usage of SIM cards based on binary input 0 state:
•
don’t care – It is possible to use the SIM regardless to BIN0
state.
•
1 – Only use the SIM card if the BIN0 state is logical 1 – no
voltage.
•
0 – Only use the SIM card if the BIN0 state is logical 0 –
voltage present.
Continued on next page
39