Azbil MagneW Two-wire PLUS+ MTG15A, Руководство пользователя

Страница: 102 / 280

5-32
5-5-9. Selecting a communication system
Select the communication system (SFC, DE, HART, and communication disable).
Select a communication system to be used. Note that the converter will be rebooted when the
MODE key is pressed to switch to the MEASURING MODE after the settings are changed.
HART: HART communication by using the HART Communicator.
SFN.A: SFC in the analog (4-20 mA) output mode.
SFN.D: DE (Digital Enhanced) communication.
NONE: Communication is not used/disable.
By default, SFN.A: SFC communication is set.
Select a communication system in accordance with the following procedure:
Step Procedure Screen
1 The screen at right is a screen display example in
MEASURING MODE (measurement state).
Press the MODE key.
20.0 %
01.94 m 3 /h
WP0 00069401
2 The OPERATOR'S MODE screen appears for approx.
two seconds, and then the damping setting screen
appears.
20.0 %
* OPERATOR'S
MODE
20.0 %
* DAMPING
005.0 s
3 Press the

three times to display the screen as shown
on the right.
20.0 %
* COM SELECT
SFN. A
4 Press the

key to move the cursor to the position for
the communication system (SFN.A, SFN.D, NONE,
HART). The screen at right shows an example where
SFN.A has been selected for the communication
system.
20.0 %
* COM SELECT
SFN. A
5 Press the

or

key to select a desired
communication system to be set.
The screen at right shows an example where HART
communication has been selected.
20.0 %
* COM SELECT
HART
6 Press the

key to move the cursor to the position
under *.
Pressing the MODE key reboots the converter, returns
to MEASURING MODE, and the communication
system changes and saved.
20.0 %
* COM SELECT
HART
8.8.8.8.8.8.8.8
RATE
TOTAL
%
SELF CHECK
MODE
20.0 %
01.94 m 3 /h
WP0 00069401
CAUTION
You have only ten minutes to return to MEASURING MODE to save the new value before
the system resets it to the previously saved value.