Azbil ATT082, Краткое руководство пользователя, Страница: 14 / 32

10
Chapter 4 Installation instructions
4-3. Installation instructions
A Phillips head screwdriver is required to mount the head transmitter.
Handling Precautions:
Do not overtighten the mounting screws as this could damage the head
transmitter.
>> Maximum torque = 1 N·m (3/4 pound-feet).
4-3-1. Mounting the head transmitter
1 2
3 4
Figure 4-2. Head transmitter mounting (three versions)
Procedure for mounting in a field housing:
1. Open the cover (1) of the field housing (4).
2. Guide the mounting screws (2) through the lateral bores of the head transmitter (3).
3. Screw the head transmitter to the field housing.
4. After wiring, close the field housing cover (1).
4-4. Post-installation check
After installing the device, always run the following final checks:
Device condition and specifications Notes
Is the device undamaged (visual inspection)? —
Do the ambient conditions match the device specification
(e.g. ambient temperature, measuring range, etc.)?
(Refer to page 9)
Handling Precautions:
Make sure the sensor type.
Make sure that the sensor type and model are correct.
Use of the incorrect sensor and model might cause temperature errors or
abnormal outputs.