Axopar 22 SPYDER, Руководство пользователя

Страница: 50 / 118

7. Maintenance
To prevent quick deterioration of the cover, secure it tightly in a folded-up position to prevent flapping.
NOTICE
• Hang to dry. Never use a drying cabinet or iron to speed up drying.
• Check that the cover is completely dry before stowing. Stowing a moist
cover can cause mold damage.
• Store the cover in dry indoor conditions for the winter.
• The cover must not be stored in the boat.
7.3.1. Cleaning the cover
The cover should be thoroughly cleaned two or three times a year.
NOTICE
Never use high pressure washers or chemical cleaning agents.
1. Let the fabric cover soak for at least 24 hours.
2. After soaking, wash the inside and outside of the cover with a sponge or a soft brush.
3. Use mild soapy water and plenty of water, max. 30°C.
4. Rinse thoroughly with freshwater.
We recommend mixing 12% vinegar in the final rinsing water to neutralize the soap residues.
5. Hang the cover to drip dry.
7.4. Preventing frost damage
• The bilge pump system is fitted with a water lock on the hose.
◦ Detach the hose and fully drain the water from the water lock and run the pumps dry.
Otherwise the pumps may freeze and break.
• Unscrew the frost plug on the underside of the shower fittings.
◦ If there is no frost plug, unscrew the shower hose.
• Drain the water tank and all other components containing water in order to avoid frost damage.
• Run the freshwater pump dry to drain out all the water.
• Make sure that no water remains in the boat under any circumstances. Leave the hatches in the
cabin partially open.
7.5. Checklist: Before winter lay-up
1. Wash the hull and bottom immediately after lifting the vessel out of the water.
2. Wash all parts inside, also under the floorboards.
3. Leave all lockers, drawers, cabin and wardrobe doors open.
Axopar 22 Spyder Document ID: 22S202103EN
Owner's Manual
© 2021 Axopar Boats Page 49
-
-