Axon Body 3 Dock
Installation Manual
Axon Enterprise, Inc.
Page 13 of 25
3.
Use the screws provided in the dock wall mount kit to attach the dock to the bracket.
4.
As the screws come out the back of the bracket, attach the washers and add the wing
nuts.
5.
Finish tightening all the screws.
Step 3: Identify Dock Placement
Determine the best wall location for mounting the dock.
1.
Look for a location away from heat sources and direct sunlight that does not obstruct
movement.
2.
Choose a location close to an electrical outlet and a network outlet. Measure the length
of the dock’s power cord to be sure that it will reach.
Step 4: Attach the Wall Mount Bracket to the Wall (Stud mount)
Your Wall Mount Kit comes with hardware for mounting the bracket to a stud or mounting
directly into drywall. If you are going to install the bracket to drywall, go to
Wall Mount Bracket to the Wall (Drywall Mount)
Note:
Use the longer screw for mounting the bracket into a stud.
1.
Using a stud finder, mark the location of each stud’s center with a pencil.
2.
Use a nail to confirm a stud has been located.
Note:
Depending on the wall construction, you may not be able to mount both ends of
the Wall Mount Bracket into the stud.
3.
Use the drywall anchors in the Wall Mount Kit for the other mounting locations if
needed.
4.
Position the Wall Mount Bracket on the wall and align the mounting keyhole in the left
side of the bracket with the center line of the stud.
5.
Use a level to ensure the bracket is level before marking the holes.
6.
Mark the center of the left side keyholes in the center of each wall stud.
7.
Using a power drill, drill a pilot hole smaller than the screw diameter.
