Axnes AS
Document number
Revision
Date
Page 2-11
2.13 Menu
The first push on the MENU button will activate the last used menu entry. The configuration
up or down buttons are used to navigate the menu tree. The OK button will select the active
entry or setting, and configuration up or down will increase or reduce the value of the
selected entry. The MENU button will step one level up in the menu hierarchy.
The menu hierarchy has two levels, one top-level which may be used during operation and
one sub-level which may be used for more permanent configurations. The menu is illustrated
below:
Display Intensity:
Display illumination intensity can be regulated in steps between 1-9. The
setting is persistent over a power off-on cycle. At start up the programmed default intensity is
used, and then gradual adapting to the user selected intensity over a few seconds.
Moving Map:
The polling of the handsets position data can be turned on and off. The
handset position is reported as NMEA command on the NMEA port of the base station.
Standby mode
DI
Display Intensity
1-9
MM
Moving Map
On..Off
AM
Advanced Menu
Refer to chapter 2.13.1
IM
Install menu
Refer to chapter 2.13.2
CO
Select configuration
C1
Config 1
C2
Config 2