Axminster SS-12VS, Руководство пользователя

Страница: 9 / 24

Setting up
9
Fig 04
a
b
Fig 05
screw stops (e) so the table does not come into
contact with the sanding disc, tighten the nuts to
lock the table stops in position. Re-tighten the table
clamps (c).
c
d e
Now the table is set correctly you may have to adjust
the pointer on the scale so it’s set to (0˚) degrees.
Loosen the Phillips screw and adjust until correct,
re-tighten the screw. (see fig 06)
Scale Pointer
Table Top Adjustment
The table top can be adjusted so it’s square to the
sanding disc. Using a Hex key loosen the two Hex
bolts in the table, see fig 6.
Fig 06
Fig 07
Using a square adjust the table until it is set to 90˚ to
the disc. Re-tighten the hex bolts.
Fig 08
Loosen the Phillips screw and line up the pointer so it
reads (0˚) degrees on the scale.
Your disc sander is now ready. Check that all fixings
are secure before operating the machine.
CONNECT THE SANDER TO
THE MAINS SUPPLY
Continues Over...