Axminster SS-12VS, Руководство пользователя

Страница: 17 / 24

Trouble Shooting
17
Fig 26
PROBLEM POSSIBLE CAUSE REMEDY
Motor will not run 1. Defective or broken
“ON -OFF” switch
2. Defective or damaged
switch cord
3. Defective or damaged
switch relay
4. Burned out motor
5. Blown fuse
6. Motor has cut out or stalled
1-3. Replace all broken or
defective parts before using
the sander
4. Contact Axminster Tool
Centre on 03332 406406 and
asked to be transferred to
the “Technical Enquiries”
Department
6. Press the 6 AMP OVERLOAD
TRIP SWITCH
Machine slows down
while sanding 1. Applying too much pressure
to workpiece 1. Apply less pressure to
sanding surface
Wood burns while
sanding 1. Sanding disc is worn
2. Excessive pressure being
applied to workpiece 1. Replace the disc
2. Reduce pressure being
applied to workpiece
6 AMP OVERLOAD TRIP SWITCH
Above the speed control dial there is a “6 AMP OVERLOAD TRIP SWITCH”. If the sander stalls from too much
pressure being applied to the disc or the motor cuts out due to overheating or over use, press this switch to
reset the sander. (see fig 26)
NOTE: WAIT TWO MINUTES AFTER THE SANDER HAS STOPPED
BEFORE PRESSING THE OVERLOAD TRIP SWITCH TO ALLOW THE COM-
PONENTS TO COOL DOWN!
6 AMP OVERLOAD TRIP SWITCH