Axminster SS-12VS, Руководство пользователя, Страница: 15 / 24

Changing the Abrasive Disc
15
Fig 20
Lower the extraction moulding
Fig 21
Disc guard plastic spacer
Fig 22
Peal off the old abrasive disc and place aside
4. The abrasive disc is attached to the sanders face
by Velcro, a strip of fabric that cling when pressed
together. Simply peal off the old abrasive disc, you
may need to use a hand brush to brush off any loose
saw dust on the disc face.
5. Line up the new abrasive disc with the face of
WEAR A DUST MASK WHEN
CHANGING THE ABRASIVE
DISC!
Fig 23
Offer up the new abrasive disc and press
down evenly onto the sanding face
CONNECT THE SANDER TO
THE MAINS SUPPLY!
Start up the sander, wait until it’s at full speed and
look to see if the abrasive disc is spinning evenly
around. If NOT switch off, wait until the sander comes
to a complete stop and repeat the procedure from
the opposite page until the disc is spinning correctly.
sanding disc and evenly press down, making sure
there are no wrinkles or air bubbles. (see fi gs 22-23)
6. Replace the disc guard, extraction moulding and
table.