Axminster SS-12VS, Руководство пользователя

Страница: 14 / 24

Operating Instructions
14
DISCONNECT THE SANDER
FROM THE MAINS SUPPLY!
1. Release the two clamping handles on either side
of the table and lower the table carefully and remove
the extraction adaptor, see fi gs 17-18.
2. Loosen the two butterfl y screws on either side of
the extraction moulding and lower carefully down.
(see fi gs 19-20). (You may need to tilt the sander to
lower the extraction moulding fully)
3. Remove the disc guard by undoing and removing
the two Phillips screws and place safely aside. (see
fi g 21)
Fig 17
Undo the tables two clamping handles
on either side and lower the table
Fig 18
Fig 19
Undo the two butterfl y screws on either side of the disc
Changing the Abrasive Disc
Variable Disc Speed
The motor on this machine is a 750W DC brush type
unit, electronically controlled to give a disc speed
of between 1,000-3,000rpm. This means that you
can choose the disc speed that is right for the job,
whatever the material. Disc speed is maintained
electronically to compensate for work loads.
Manual Disc Brake
A manual disc brake is fi tted to allow the disc to be
stopped quickly if required. (see fi g 16)
Fig 16
NOTE: BE CAREFUL WHEN REMOVING
THE SCREWS AS THERE ARE TWO
PLASTIC SPACERS BETWEEN THE DISC
GUARD AND THE REAR MOULDING!