05
Initial Assembly and Testing
!
I
deally, your mill should be installed close to a correctly rated power supply, in a warm
dry environment, well ventilated and illuminated by bright clear natural light, with
adequate access all around the machine, and sufficient adjacent storage space for your
tools, accessories and material.
The Micro-Mill is best mounted on a rigid bed; this is to ensure stability of the machine and to
attenuate any vibration that is generated when the machine is running.
The bed should be flat and set level in both planes, and at a height that enables comfortable
operation of the machine. It is not necessary to anchor the bed through to the floor, but it must
be stable enough to remain immovable during any normal forceful operations (especially
tightening) carried out whilst operating your mill.
If you are preparing your own bed for the machine, it should be at least 400mm long by 250mm
wide; (to cover the footprint of the base (354 x 216), you will need to drill 4 No. 8.5mm holes to
allow for bolt fixing. Set out the centres of the holes in the following matrix: - 294mm x 186mm
Bolt the mill to the bed using M8 nuts, bolts and washers.
Locate and identify the 3 rod handles from the packing box. Fit these to the 3 wheel
handles, (Work table control, traverse feed control, head raise and lower control.)
Please read the section entitled Identification and Parts description so that you
may more easily identify the parts to which reference is made in the text.
Testing
When the lathe is mounted to your satisfaction, proceed as follows:-
a)
Close the chuck jaws
b)
Check the millhead is ‘locked’ in position on the column.
c)
Check that all loose items are removed from the worktable.
d)
Set the worktable approximately mid-positioned under the chuck jaws.
e)
Check the speed control is switched OFF (fully anti-clockwise).
f)
Check the Forward/Off/Reverse Switch is in the Off position
g)
Select L (Low) on the gear box .
h)
Connect the machine to the mains supply and switch power on.
i)
Turn the Speed Control Switch On (Clicks On) and Select Forward on the Forward/Off/Reverse
switch.
J)
Check the Amber LED (Fault Light) is illuminated and the green light is illuminated.
k)
Switch the Speed Control Switch Off ( Clicks Off) and the Amber Led is now Off and the Green
light stays on.
l)
Turn the Forward/Off/Reverse switch to Off position (Clicks Off) all lights are now off.
m)
Select Forward on the Forward/Off/Reverse switch.
n)
Turn the Speed Control Switch On and advance until the Chuck starts to rotate.
o)
Turn the Forward/Off/Reverse switch to Off position, check that the machine stops, turn the
Forward/Off/Reverse switch to Forward, check that the Green light comes on and the Amber LED
comes on and the machine does not start. Turn all switches off ( All lights are off).
p)
Turn Forward/Off/Reverse switch to Forward.
Содержание SIEG X1 Super Micro Mill Mk2
