10
Contour Sanding
Referring to Figure 19:
Contour sanding
is done from the extension table
mounted on the motor where the sanding belt
wraps around the
drive drum
(D). To set up the
sander for contour sanding:
1. Loosen the two
lock knobs
(C) that secure the
drum guard & dust port
(E).
2. Swing the
end guard
(E) back, bringing the
drive drum
(D) into view.
3. Tighten
the
lock knobs
(C).
4. Mount
the
extension table
(A) to the sander by
inserting the
post
(B) into the
bracket
(F).
5. Set the table to the desired height, then secure
into position by tightening the
lock knob
(G).
Important:
When the
extension table
(B) is not in
use, the
drum guard & dust port
(E) should always
be in the closed position so the
drive drum
(D) is
not in view.
Figure 19
