Axminster Trade 105644, Оригинальное руководство пользователя

Страница: 19 / 28

Accessories
19
Instructions
Use the cones in a drill press or your morticer if you have a
chuck adaptor (a handheld drill is neither suitable nor safe).
Clamp the bit vertically and securely, or drill a hole in a block of
wood the same diameter as the chisel’s shank. The chisel must
be held firmly and perpendicular.
Fasten the coarse cone in the chuck and align it with the chisel
so it centres exactly in the end of the chisel, do this BEFORE
switching on. Running at low speed (150 to 250rpm), gently
lower the cone until it just makes contact with the mortice
bit. Carefully grind until you obtain a clean surface around the
entire bevel. Replace it with the 350-grit cone and repeat the
process, lightly honing the inside bevel. Use a fine flat stone lap
the sides of the bit to remove any burrs.
Axminster Heavy Duty Mobile Base
Our heavy duty mobile base has two fixed wheels at the rear
and features two castoring wheels at the front. It is a practical
method for manoeuvring heavy machines into position safely
and with ease. Maximum total load is 540kg and the size limits
are 460mm x 620mm minimum, up to 720mm x 850mm
maximum.
Code: 105072
Maintenance
WARNING!! DISCONNECT THE MORTICER FROM THE
MAINS SUPPLY BEFORE CONTINUING!
After long periods of use, if you notice a degree of side play
developing on both the table and head stock, you will need to
adjust the gib strip screws until the slide play is eliminated.
Table and Head Stock Adjustment
To adjust the left to right movement slacken the two Hex
locking bolts (A) beneath the right hand side of the table then
very carefully adjust the two gib strip screws (B), see fig 35.
NOTE: make small adjustments, turning the operating wheel
until the table slides smoothly across, but not too much
causing the table to tighten or jam.
When you feel the slide play has been eliminated, tighten
the two locking Hex bolts (A) to secure the setting.
Table Adjustment Left to Right
Table Adjustment Front to Back
To adjust the front to back movement slacken the three locking
nuts (C), to the rear of the table, then using a Hex key adjust
the three gib strip grub screws (D) until the side play has been
eliminated. Tighten the locking nuts (C) to secure the setting,
see figs 36-37.
Fig 35
Fig 36-37
C
D
B
A