OSD Menu Setting
OSD Menu Setting
PTZ
CAMERA
PTZ
CAMERA
018
019
C-5. INITIALIZATION
This is for removing the informations of PRESET/TOUR/SECTOR/PRIVACY/
PATTERN saved in Memory, on choice for LOAD OPTIMIZED DEFAULT, all of
value should be initialized to FACTORY DEFAULT.
C-6. PREVIOUS PAGE
THis is for moving on former page.
MAIN MENU
DOME SETUP
CAMERA SET
PRESET
AUTO SCAN
TOUR
PRIVACY
PATTERN
ALARM
SECTOR
EXIT
INITIALIZATION
[TOUR CLEAR]
[PRESET CLEAR]
[SECTOR CLEAR]
[PRIVACY CLEAR]
[PATTERN CLEAR]
[LOAD OPTIMIZED DEFAULT]
[PREVIOUS PAGE]
D. CAMERA SET
• You can set it up on module operating in the CAMERA SET MENU.
• Possible to enter using Left/Right of Joystick after choose CAMERA SETUP
from MAIN MENU OSD.
C-3. OSD DISPLAY
Each part can be set up into ON/OFF, on On, remark operating sign in the
designed place.
C-4. SYSTEM STATUS
This is for checking the information of IR SPEED DOME, instruction is below.
• PROTOCOL : Communication Protocol information between Controller and
SPEED DOME.
• RAUD RATE : Communication Speed information between Controller and
SPEED DOME.
• FIRMWARE VER : Version information of Firmware used in product.
• UPGRADED DATE : Information on final writing day of the firmware.
• CAMERA MODULE : Module information used in product.
• R/B UPGRADED DATE : Information of final writing day on firmware of the
REAR BOARD.
OSD DISPLAY
CAMERA ID
ON
PRESET ID
ON
SECTOR ID
ON
TOUR ID
ON
PATT ID
ON
SCAN ID
ON
COORDINATE ON
[PREVIOUS PAGE]
• Password should be inputted 2 times using number, preset key.
• In case of same thing with PASSWORD input of 2 times, "CONFIRMED"
will be showed up and back to the Menu after 4 second.
• Basic value of PASSWORD : 99
SYSTEM STATUS
PROTOCOL
PELCO-D, P
BAUD RATE
2400 BPS
FIRMWARE VER
1.00a
UPGRADED DATE
09.02.11
CAMERA MODULE
SCM3270
R/B UPGRADED DATE 01.K.10
[PREVIOUS PAGE]
