Axis StorPoint HD, Руководство пользователя

Страница: 82 / 95

Appendix B: The Config File
AXIS StorPoint HD 81 User’s Manual
Appendix B The Config File
Parameter name Value Description
[Server]
HardwareAddress = 00:40:8c:11:00:86
The StorPoint HD hardware address. Default setting is the serial
number, or you can set a Locally Administrated Address. The
value shown is an example only.
Date = 97-01-01
yy-mm-dd, enter the date followed by ! to set manually
Time = 12:00:00
hh:mm:ss, enter the time followed by ! to set manually
FactoryDefaults = no Set this parameter to yes to reset to factory default settings.
Restart = no
Set this parameter to yes to restart the StorPoint HD.
[SCSI]
SCSITermination = on
Internal SCSI termination setting. This is always on, therefore the
StorPoint HD must always be located at the end of the SCSI bus.
[IP]
InternetAddress = 192.36.253.80
The StorPoint HD Internet address. The value shown is an
example only.
DefaultRouter = 0.0.0.0
All traffic directed outside the local network (according to the
NetMask) is sent to the default router. Any re-routing via other
routers is done automatically. The default 0.0.0.0 indicates that
no default router is set.
NetMask = 0.0.0.0
Used to determine when the traffic should be sent via a router.
For example the normal class C mask is 255.255.255.0. The
default 0.0.0.0 indicates that automatic router sensing is used.
BOOTPEnable = yes
Enable or disable bootp IP address setup.
RARPEnable = yes
Enable or disable rarp IP address setup.
DHCPEnable = no Enable or disable dhcp IP address setup.
[SMB]
EnableNetBEUI = yes Enable or disable SMB over NetBIOS/NetBEUI.
EnableNBT = yes
Enable or disable SMB over NetBIOS/TCP/IP.
EnableWINS = yes Enable or disable WINS over NetBIOS/TCP/IP.
PrimaryWINSserver =
Primary WINS server address.
SecondaryWINSserver = Secondary WINS server address, if required.
NBTscopeID =
Always Enabled. Default: Empty String.
Domain/GroupName = WORKGROUP The name of the StorPoint HD workgroup.
ServerName = AXIS110086
The server name in the Microsoft Network environment, where
110086 are the last 6 digits of the serial number. The value
shown is an example only.
NetBEUIFrameType = auto If auto is selected 802.2 or DIX will automatically be selected by
scanning the network. If required, the frame type can also be set
to either 802_2 or DIX.
ShowPseudoShares = yes
Enable or disable whether the cd, config, root, and volumes
folders are visible.