AXIS Q3518-LVE Network Camera
Specifications
Function Button
The function button has multiple functions:
•
As leveling Assistant
– This function helps to ensure the image is level. Press the button for about 2 seconds to start the
leveling assistant and press again to stop. The status LED (see ) and buzzer signal assist leveling of the image. The image is
level when the buzzer beeps continuously.
•
To view the Status LED
– Press the button once to light up the Status LEDs. Press again to turn them off. The LEDs
will turn off automatically after 10 seconds.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
Audio connector
•
Audio in
– 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
•
Audio out
– 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A stereo connector must be used for audio out.
1 Tip
2 Ring
3 Sleeve
Audio Input
Microphone/Line in
Microphone bias voltage
Ground
Audio Output
Line out, mono
Line out, mono
Ground
For audio in, the left channel is used from a stereo signal.
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
Digital input -
For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Supervised input -
Enables possibility to detect tampering on a digital input.
Digital output -
For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface or from the product’s webpage.
4-pin terminal block
19
