AXIS Q1942-E PT Mount Thermal Network Camera
About system options
To clear all recordings and data from the Axis product’s folder on the designated share, click
Clear
under
Storage Tools
.
To avoid filling the share, it is recommended to remove recordings continuously. Under
Recording Settings
, select
Remove recordings
older than
and select the number of days or weeks.
To stop writing to the share and protect recordings from being removed, select
Lock
under
Recording Settings
.
Ports & Devices
COM Port
The Axis product has one RS-485/RS-422 serial port. The port supports the following modes:
•
Generic HTTP
allows the Axis product to receive data and send commands via HTTP.
•
Pan Tilt Zoom
is used to control a PTZ device. The PTZ device requires a driver. See
for more
information. Drivers can be downloaded from www.axis.com
•
Generic TCP/IP
allows the Axis product to receive data and send commands via TCP/IP.
Select the desired
Port Type
from the drop-down list. For more information, see the online help
.
Maintenance
The Axis product provides several maintenance functions. These are available under
System Options > Maintenance
.
Click
Restart
to perform a correct restart if the Axis product is not behaving as expected. This will not affect any of the current
settings.
Note
A restart clears all entries in the Server Report.
Click
Restore
to reset most settings to the factory default values. The following settings are not affected:
•
the boot protocol (DHCP or static)
•
the static IP address
•
the default router
•
the subnet mask
•
the system time
•
the IEEE 802.1X settings
Note
If the Axis product is restored, uploaded applications and their settings are removed.
Click
Default
to reset all settings, including the IP address, to the factory default values. This button should be used with caution. The
Axis product can also be reset to factory default using the control button, see
How to reset to factory default settings on page 51
For information about firmware upgrade, see
How to upgrade the firmware on page 52
49
