Axis M7014, Руководство по установке

Страница: 14 / 88

AXIS M7014 Video Encoder
RS485/RS422 TX A
3
RS485/RS422 TX B
4
(TX) For full duplex RS485/RS422
Install the Hardware
Important
The casing is not approved for outdoor use. The product may only be installed in indoor
environments.
Note
• The AXIS M7014 can be placed on a flat surface or mounted on a wall.
• Punch out the protective pads and stick them to the underside of the video encoder to
prevent scratches on the surface where the video encoder is placed.
Mount the Video Encoder
1. Place the video encoder against the wall, and mark the four mounting holes.
2. Drill the four mounting holes.
3. Insert the provided wall plugs into the wall, and fasten the video encoder to the wall
using the screws provided.
Connect the Cables
Note
The unit can be powered using either the DC power input or PoE.
If powering the unit using DC power, connect the power supply to the power connector at
the rear of the unit.
If powering the unit using PoE, connect a PoE network cable.
1. Connect the encoder to the network using shielded network cables.
2. Connect the cameras to the video inputs.
3. If powering the unit with DC input, connect the supplied indoor power adapter or an
external power supply.
4. Check that the indicator LEDs indicate the correct conditions, see LED Indicators on
page 10 .
Access the Product
AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products
on the network and assigning them IP addresses in Windows®. Both applications are free and can
be downloaded from
www.axis.com/techsup
14