2022-01-10 | Technical improvements, changes in design, printing- and other errors reserved. | BA_MIP-8-16-0x.pdf
Page 21 of 48
4.2.3.
MPTS
If MPTS (Multi Program Transport Stream) is selected as the transport stream output (see 5.2.1 on page 33), then the programs
can be assigned to the 8 or 16 output transport streams.
All lines of the programme table have colored buttons M1, M2 …. The buttons correspond to the MPTS. The allocation of the
buttons is given in the COLOR CODES legend.
You can assign programmes in REMUX MODE or in CROSS MULTIPLEX MODE.
With each programme you asign to an MPTS, the data rate rises.
The performed modifications are only taken over by the system when you click on SAVE CHANGES.
4.2.4.
MPTS – Remux mode
If the the Net
work ID
are set on
auto
, the device works in the Remux mode. In this mode, the IDs from the set transponder
and from the satellite are used and forwarded with virtually no changes. The
TS ID1
to
TS ID8/16
of the MPTSs, are also set
on
auto
.
Note:
If the device is already set to CROSS MULTIPLEX MODE, set the
Network ID
to
auto
.
Click on SAVE CHANGES.
The device ist set back to REMUX MODE.
