SAFETY
WARNINGS
SAFETY WARNINGS
The installation and servicing instructions in this manual are for use by qualified personnel only.
-
Read All Instructions.
All safety and operating instructions must be read before operating the product.
They also must be retained for future reference, as it contains a number of useful hints for determining
the best combination of equipment settings for Yr particular application.
-
Heed All Warnings
. All warnings on the product and those listed in the operating instructions must be
adhered to.
-
Heat
. This product must be situated away from any heat sources such as radiators or other products
(including power amplifiers or transmitters) that produce heat.
-
Power Sources.
This product must be operated from the type of power source indicated on the marking
label and in the installation instructions. If you are not sure of the type of power supplied to your facility,
consult your local power company. Make sure the AC main voltage corresponds to that indicated in the
technical specifications. If a different voltage (ex. 110/115 VAC) is available, open the equipment closure
and set the voltage switch on the main supply circuit, located behind the AC socket
-
Power Cord Protection.
Power supply cords must be routed so that they are not likely to be walked on
nor pinched by items placed upon or against them. Pay particular attention to the cords at AC wall plugs
and convenience receptacles, and at the point where the cord plugs into the product
-
Use only w ith a cart,
stand, tripod, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury
from tip-over.
-
Lightning
. For added protection for this product during a lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the AC wall outlet and the audio connections. This will
prevent damage to the product due to lightning and power line surges
-
Installation
. Configuration and installation should only be carried out by a competent installation engineer
-
Cabling
. Using high quality wires, well protected. Make sure the cable integrity.
This symbol alerts you to the presence of dangerous v oltage inside the closure – v oltage
w hich may be sufficient to constitute a risk of shock. Do not perform any servicing other
than that contained in the operating instructions. Refer all serv icing to qualified
personnel
The exclamation point w ithin an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (serv icing) instructions in the
literature accompanying the appliance
.
Do not change the v oltage setting or replace the mains fuse without first turning the
unit off and unplugging the mains cord
Make sure the AC main voltage corresponds to that indicated in the technical
specifications.
THIS APPARATUS MUST BE EARTHED !
To av oid risk of fire use the correct value fuse, as indicated on the label stuck on the
right side of the unit.
This apparatus uses a single pole mains sw itch and does therefore not separate the
unit completely from the mains pow er. To completely separate from mains pow er
(f.i. in the event of danger) unplug mains pow er cord.
As the MAINS plug is the
disconnect dev ice, the disconnect dev ice shall remain readily operable.
