AWS AIRBAR, Руководство оператора

Страница: 12 / 20

A WS AirBar Operator’s Manual
8
OPERATING THE SYSTEM
DAILY CHECKS
Safety Shields In place
Rotary Screen Rotates freely
Clear of trash
Nozzles Properly secured to manifold
No bent / broken nozzles
Electric Controls Throttle & manifold tilt actuators
function properly
Electrical
Connection Plugs secured at header
Harness is secured
REEL POSITION
The use of the AirBar system aids not only in reducing shatter
loss but also the inflow of crop material, assisting the finger reel
system.
In most cases, shatter loss can be reduced further with the
ability to set the finger reel higher than if an AirBar system is not
used.
W
hen entering the crop, begin with the reel the “normal” height
and begin to raise the reel until you see a decrease in
performance.
MANIFOLD HEIGHT ADJUSTMENT
The manifold height can be adjusted in accordance with the
desired reel position. In most applications the mid-height
adjustment hole is appropriate.
It is important that the “heel” of the nozzle (area of the bend) is
2- 4” higher from the ground than the nozzle tip when in the
operating position.
ELECTRICAL CONTROLS
All nozzle and air flow adjustments for the AirBar system are
made using the electrical switch box installed in the cab.
There are 2 separate switches:
1. Air Volume (Cycles Throttle Actuator)
+ Increase Air Output
- Decrease Air Output
2. Nozzle Tilt (Cycles Manifold Tilt Actuator)
+ Tilt Nozzle toward head
- Tilt Nozzles Away from Head
1
2