ATEX Retractor System TANKO-RT/-RTS
36/121
Translation - Operating/installation instructions 2020/01
3 Design and Function
3.3
Technical Data
The estimated safe service life of the device is 10 years with single-shift operation and the use of
drinking water.
The prerequisites for this are that the device must be maintained properly at the intervals specified in
Section 7.4 Maintenance
, and the wear parts must be replaced regularly.
All media other than tap water can reduce the service life of the device.
NOTE ON EXPLOSION PROTECTION
Restriction of the operating parameters of the device!
The maximum permitted operating parameters such as container size, operating pressure
and flow rate must be taken into account due to electrostatic charge build-up when
handling fluids.
If this is not observed, the explosion protection could be disabled.
Comply with the notes in
section 3.4
recommissioning the device.
General Technical Data
Designation
TANKO-RT/RTS
Ambient temperature (permitted):
outside the container
–
During the cleaning process
–
In idle state
+5 °C (+41 °F) to +40 °C (+104 °F)
-10 °C (14 °F ) to +40 °C (+104 °F)
Operating pressure range in the
container to be cleaned
-
During the cleaning process
-
In idle state
0.0 to 0.5 bar (0.0 to 7.25 psi g)
There is no potentially explosive mixture in the container during
cleaning. The cleaning medium must not even result in the
development of potentially explosive mixtures during spraying.
0.0 to 0.1 bar (0.0 to 1.45 psi g)
There is a potentially explosive atmosphere in the container
during cleaning
-1.0 to 3.0 bar (-14.5 to 43.5 psi g)
Installation dimensions:
see
Plant noise level:
L
pA
max. = 70 dB(A)
Materials:
in contact with media
–
other
1.4401, 1.4430, 1.4435, PTFE-TMOF-0040, EPDM, optional:
FKM (e.g. Viton
®
), FFKM (alternative materials in line with
customer order, see supplementary “Special version” sheet)
1.4301, 1.4404, PU, EPDM optional: FKM (e.g. Viton
®
), Al
Table 3.3-1: General Technical Data