Copyright 2022, AWE. No part of this document may be reused or duplicated without the express permission of AWE/Secor Ltd. All rights reserved. Rev3.7
Make a cut on the driver and passenger side exhaust tube along the rear edge of the tape, as
shown in
Figure 4
-
1
and
Figure 4
-
2
.
NOTE: It is crucial that these cuts are accurate. Incorrect cuts will effect fitment.
Make sure that the cuts are perpendicular to the tube you are cutting.
On the passenger side catalytic converter
measure
7.00”
inches from the weld seam (
A
)
towards the rear of the vehicle.
Mark with tape (
B
) and an arrow pointing to
rear of the vehicle, as shown in
Figure 3
.
It is extremely important that these
measurements are accurate as it will
effect fitment.