Copyright 2022, AWE. No part of this document may be reused or duplicated without the express permission of AWE/Secor Ltd. All rights reserved. Rev3.7
Reinstall the hardware into the OE rear
hangers (
A
), as shown in
Figure 17
-
1
.
Plug the OE connector into the valve motor,
shown by (
B
).
Note
: Unclip to OE harness from the chassis
on both the driver and passenger sides to al-
low the harness to reach the AWE pipes, as
shown in Figure 17
-
2 and 17
-
3.
Note
: Do so on both the driver and passenger
side.
AWE SWITCHPATH SYSTEM, SKIP TO STEP 25.
For the rear sections, hanger bar collar clamps
are provided to prevent side to side movement
of the exhaust system. After sliding the exhaust
hanger bar through the OEM grommet, install
the collar clamp on the outside end of the bar
as shown in
Figure 18
.