1. OVERVIEW
3. INSTALLATION
2. CABLE CONNECTIONS
2
1
■
Please read this instruction carefully before using the
All the examples and pictures used here are for reference
The content of this manual are subject to change without
product and keep it for further reference.
■
only.
■
notice.
►
Connecting Network Cable
1
2
Power connector
Ethernet connector
3
Safety wire
1
2
3
①
Loosen the nut from the main element.
②
③
Connect the cable to the hermetic connector. Then tighten
the nut and the main cover.
Run the network cable (without RJ 45 connector) through the
both elements. Then crimp the cable with RJ 45 connector.
3
Micro SD Card Installation
Please make sure the wall is strong enough to bear the
dome camera’s weigh and the camera is powered off
during installation.
This PTZ camera supports wall or ceiling mounting. Please
select a way to install as needed. The following instructions are
for reference only.
Insert a micro
SD card
1. Loosen the four screws of
the cover and then remove
the cover.
2. Insert a micro SD card as
indicated above and then install
the cover back.
Wall Mounting
1. Pull the cables through
the bracket.
3. Drill the screw holes on the wall
according to the drill template.
Then insert the plastic plugs into
the holes.
4. Fix two screws to the holes
as indicated by the arrows (left)
and leave 12mm clearance.
5. Connect the cables and
then hang the bracket on the
wall.
6. Fix the bracket to the wall
with four screws.
2. Secure the PTZ camera to
the bracket with screws.
12
Quick Start Guide
HD PTZ Camera
Network Cable
DC12V
