Avocent Cyclades ACS 6000, Инструкция по установке/администрированию/использованию, Страница: 43 / 90

Chapter 4: Using the Web Manager
31
To edit Static Routes:
1. Select Appliance Settings - Network - IPv4 Static Routes or IPv6 Static Routes. Any existing
static routes are displayed with their Destination IP/Mask, Gateway, Interface and Metric
values shown.
2. Click a route name under Destination IP/Mask. The Static Routes edit screen appears.
3. Edit any of the static route fields.
4. Click Save , then click Close .
DNS options
An administrator can select configure primary and secondary domain name system (DNS) servers.
To configure DNS:
1. Select Appliance Settings - Network - DNS . The DNS configuration page is displayed.
2. Enter the Primary DNS IP address.
3. Enter the Secondary DNS address.
4. Enter the Domain name, for example, corp.avocent.com (default).
5. Enter the hostname of the console server, for example,
ACS60<#ports> - <serial#>
(default).
6. Click Save .
Host options
An administrator can configure a table of host names, IP addresses and host aliases for the local
network.
To add a host:
1. Select Appliance Settings - Network - Hosts . The Hosts page is displayed and contains the IP
address, Hostname and Alias for all local hosts on the network.
2. Click Add to add new host. The Add Host Wizard page is displayed.
3. Enter the IP address, hostname and alias of the host you want to add.
4. Click Save , then click Close .
To edit a host:
1. Select Appliance Settings - Network - Hosts . The Hosts page is displayed and contains the IP
address, Hostname and Alias for all local hosts on the network.
2. Click on the IP address of the hostname that you want to edit. The settings screen is displayed.
NOTE: The IP address of the selected host is shown but cannot be edited from this screen.
3. Enter a new hostname and alias, as applicable.
4. Click Save , then click Close .