Assigning Names to the Extensions
48
FRITZ!X USB – 6 Configuring FRITZ!X USB
Assigning Names to the Extensions
Four extensions are available on the FRITZ!X USB. You can
enter a description for each extension.
1.
Select the “General” settings page in the “Settings”
menu.
2.
You can enter a name for each extension in the window
area labelled “Assigning Internal Parties/Devices to the
Extensions”.
Checking the Charge Unit
If you would like to use the charge statistics of FRITZ!X, make
sure that the charge unit entered here is correct for your ISDN
line. The charges are calculated on the basis of this value.
1.
Select the “General” settings page in the “Settings”
menu.
2.
In the “Charge Unit” section of the window, enter the
cost of one unit. The currency symbol displayed
depends on your computer's currency settings (“Control
Panel / Regional Settings”). The value can be changed
here.
Make sure that your ISDN provider has enabled the trans-
mission of charge information on your line.
Entering MSNs
Your ISDN provider supplied 3 to 10 numbers for your ISDN
line. These numbers are known as Multiple Subscriber
Numbers (MSNs). The Multiple Subscriber Numbers facilitate
the direct dialing of connected devices like telephones,
answering machines or fax machines. A terminal device can
only be dialed directly when it has been assigned its own
MSN. Before assigning the MSNs to individual extensions,
you must first tell the FRITZ!X software which MSNs are
available. To do this, perform the following two steps:
F!XUSB-e.book Seite 48 Mittwoch, 8. November 2006 2:23 14
