Starting the Configuration Software
FRITZ!X USB – 6 Configuring FRITZ!X USB
47
6.3 Starting the Configuration Software
Start the configuration software by selecting “Start / (All)
Programs / AVM / FRITZ!X”.
The first time you start the configuration program, the
Configuration Wizard opens with a welcome window. Follow
the instructions on the screen of the Configuration Wizard to
make the basic settings for your FRITZ!X USB.
You can also start the Configuration Wizard at a later point in
time by selecting “File / Wizard...” from the main window of
the configuration program.
6.4 Adjusting Settings
In order to use all of the commands of your PBX, you should
adapt the settings listed below. If you configured your PBX
using the Configuration Wizard, than these settings are
already in effect.
Among these settings are:
z
assigning names to the extensions
z
defining the local dialing prefix
z
changing the charge unit
z
entering MSNs
z
assigning MSNs to the extensions
z
assigning numbers for outgoing calls
The following sections explain how to go about configuring
the settings. Perform the settings in the order presented
here.
H
Have ready the documents in which your ISDN provider
supplied the Multiple Subscriber Numbers (MSNs) for your
ISDN line.
F!XUSB-e.book Seite 47 Mittwoch, 8. November 2006 2:23 14
