AVM ISDN CAPI Port Driver
FRITZ!X USB – 5 FRITZ!: Internet and ISDN Software
41
AVM ISDN CAPI Port Driver
The AVM ISDN CAPI Port Driver allows you to use an ISDN-
Controller integrated in FRITZ!X USB as if it were a modem.
Programs designed to communicate with modems can use
the AVM ISDN CAPI Port Driver to address the ISDN interface.
This means that all of the various communications options of
Windows can be used with all AVM ISDN-Controllers. For
example, you can use Dial-Up Networking and the TCP/IP
protocol to dial into your Internet Service Provider.
The ISDN CAPI Port Driver creates a number of virtual
modems in your system, each of which is configured such
that it can be used immediately with most applications.
These modems can be selected in Windows applications
such as Dial-Up Networking and Microsoft
Exchange/Outlook. Just select a pre-configured destination
to launch ISDN communication.
The modem settings can be customized by means of AT
commands. For more information, see the Online Help of the
AVM ISDN CAPI Port Driver. The Online Help is located on the
SOFTWARE\CAPIPORT\CAPIPORT.<OPERATING SYSTEM\ENG>
folder on the installation CD.
5.6 Ready to Receive on Standby
If your computer supports ACPI (Advanced Configuration
Power Interface), you can take advantage of the energy-
saving features of standby and hibernation.
These two conditions differ in the following ways:
z
Standby: all devices that consume large amounts of
energy are turned off, such as the monitor, hard disks
and other devices.
z
Hibernation: also saves the contents of main memory
to the hard disk. In this condition energy consumption
is even lower than on standby.
Computers on standby or in hibernation appear to be
switched off. Both conditions are ended by operating the
keyboard or the power switch. Standby can also be ended
F!XUSB-e.book Seite 41 Mittwoch, 8. November 2006 2:23 14
