Installing FRITZ!Box Fon in a Linux Operating System
FRITZ!Box Fon – 2 Starting FRITZ!Box Fon Operation
29
Installing FRITZ!Box Fon in a Linux Operating
System
The example of SUSE Linux 9.1 is used here to describe how
to install FRITZ!Box Fon to the USB port in Linux.
You have to be logged in as
“
root
”
to configure the neces-
sary settings.
1.
Open the YaST Control Center.
2.
Select the option “Network Devices” and click “Network
Card”.
The “Network cards configuration” dialog appears.
3.
Select “Other (not detected)” and the “Configure...”
button.
4.
The device type of the network in the “Manual network
card configuration” window should be set to “Ether-
net”. Select the “USB” check box as well and click
“Next”.
5.
In the input mask “DSL Configuration”, the PPP mode
should be set to “Ethernet”, for “Network cards to con-
figure” select “Other (not detected)”. Then click “Con-
figure...”.
6.
In the next dialog, “Network address setup”, select the
“Automatic address setup (via DHCP)” option. Click
“Next”.
7.
Changes to the configuration take effect when the “Fin-
ish” button is clicked.
In SUSE Linux 9.1, only one Ethernet adapter at a time can be
set to DHCP. If you have an additional network adapter, as-
sign it a fixed IP address. Otherwise problems may arise
with name resolution (cf. /etc/resolv.conf).
For comprehensive information on the topic of network con-
figuration in Linux, see:
http://www.linux.org/docs/ldp/howto/NET3-
Please see the instructions in the next section.
FRITZ!Box_Fon-e.book Seite 29 Mittwoch, 11. Mai 2005 5:33 17
Содержание Fritz!Box Fon
Страница 1: ......
