Add casters to a K-series Loom
Updated: June 8, 2021
Page | 1
AVL Looms
2360 Park Avenue
Chico, CA 95928-6785
U.S.A.
530 893-4915
530 893-1372 fax
www.avlusa.com
Drill the holes for the casters
There are four casters, which should be placed at each corner of the loom.
The holes that need to be drilled are size H or 0.266 inch diameter. Two thru
holes will need to be drilled for each bracket.
Note:
The casters are attached to the side of the loom. On the rear legs, the holes
are drilled through the narrow side of the leg. Please read all of this handout
and review the pictures on pages 3 & 4 before drilling the holes.
1)
Use the front casters diagram to determine where the holes should
be drilled on the front legs. Mark the position of the hole on the
loom.
Figure 1 - Drill diagram for front legs
