AAQ Controller Interface Panel (CIP)
13
Figure 11 - Custom Screen Example
3.4.
AAQ CIP and CIP Handheld Menu Features
The following is a list of menu features that apply to both the main CIP and the CIP Handheld device.
I.
Limited User Screens
a.
Optional Custom Main Screen which allows the display of any AAQ Variables (Sensor Outputs), as well as the
short or long Command Response Messages.
b.
Two (2) prompt screens which explain the STOP and GO buttons as described in section 3.2 above.
c.
World and positioner based angles and the ability to Peak or Repeak
d.
View limits and alarms details
e.
Active and stored profiles
f.
If the system has been configured to support a moveable Sliding Feed then Feed Slide Control
g.
Jog
II.
Extended Technical User Screens
a.
Alter fast and slow speeds
b.
Select alternate heading source (includes manual entry)
c.
Alter target satellite scan width
d.
View software versions
e.
Demo show movements (Prompt Only)
f.
Operational Modes to support future modes (Prompt ONLY)
Some parameters configured in the extended user mode may not be retained (saved) when power cycling the AAQ CIP.
A detailed list of parameters that will be saved verses non-saved is listed below.
I.
Saved Parameters
By pressing the stop and go keys at the same time, these parameters can be saved; however, they
will revert back to their default values after a power cycle is performed.
a.
Fast and slow speed configuration
b.
Compass off
c.
Scan width
d.
Compass – Manual compass. This includes manual heading
