2. Installation
1.
Secure the Panachrome
+
Controller in a suitable position on top of car to avoid damage.
2.
Connect the Controller with the correct supply voltage and Inputs (see Fig 3 below)
3.
Once the detectors are installed (see detector installation guide) it is important to ensure that the detector cables &
travelling cables (015 455) are secured to the door correctly, and that the travelling cables are routed to the Controller
correctly.
4.
Connect the Transmit (TX) and Receive (RX) leads into the Controller sockets (see Fig 4). Note: either socket can be
used as the intelligent software will recognise which detector is plugged in.
5.
On completion, carefully open and shut the doors by hand to check the travelling cable (015 455) has a smooth free
movement and is not liable to snag on anything during normal operation, otherwise there is a risk of cables being
damaged by the lift doors or caught when the lift moves.
6.
With correct operation the display will show the following for a short time:
Note: the number following TX/RX is the number of PCBs in each detector.
If different, then please check all connections.
7.
The Green and Red Indicators will be operated by software but, if required, external signalling can be used (see Table 1
and Fig 5).
Note: Before installing make sure the units are compatible to ensure reliable and trouble-free
operation:
The Panachrome
+
Controller G3851 is designed to operate with both Panachrome
+
2D Detectors [G2510 & G2540] and
Panachrome
+
3D detectors [G3510 & G3540] - check you have the correct items.
Memco Panachrome
+
Universal Controller
Installation Guide
Ref No. G851 855ML GB Version 1
Panachrome
+
TX
5 RX 5
1. Connections
Covers
To access the connections on the Controller it is necessary to remove the end covers protecting the terminals.
The Right Hand Cover conceals the terminals for connecting the external speaker and detector sockets. The Left Hand
Cover is for the power, relays and external door signals (see Figs 1 and 2).
