Avipas AV-1362U, Руководство пользователя

Страница: 27 / 45

23
4. Network Connection
4.1 Connecting Mode
Direct connection: Connect the camera and computer directly via Ethernet cable.
IP connection mode: Connect the camera to a Router or Switcher. The user can log in to access the device using
browser.
Note: Please do not put the power cable and Ethernet cable in places where can be easily touched to prevent video
quality loss caused by unstable signal transmission.
Please make sure that your computer is in the same network segment as the camera IP address. The device will not
be accessible if the segment is not consistent. For example, AV-1082’s default IP address is 192.168.5.163, then
segment 5 must be added to your computer. Specific steps are as below:
•
Open “Local Area Connection Properties” on
computer, select the “Internet protocol version 4(TCP/IPv4)”
as shown in the picture on the left.
•
Double click or click the property of Internet
protocol version 4 (TCP/IPv4) to enter the Internet Protocol
Version 4(TCP/IPv4) Properties window.
•
Select “Advanced” to enter the Advanced TCP/IP
Setting. Add IP and subnet mask in the IP browser as shown
in the picture below. Click “Confirm” to finish the adding IP
segment.
•
User can add the corresponding network segment
according to the revised IP address of the camera.