8
BOOM-1 T
acTile
T
ransducer
P
rOcessOr
u
ser
G
uide
When the internal amplifier section is in Protect mode, the red
a
Mp
C
LIp
/p
roteCt
LED will continue to flash
until such time that the internal circuitry reaches a safe operating temperature and normal operation can
be restored. The time it takes for this to happen will vary and is dependant upon the unit’s current internal
temperature, how the unit is mounted, and the ambient temperature of its surroundings.
BOOM-1
Tactile Transducer Processor
In
Thru
Tight
Loose
Amp
Clip/Protect
Signal
Clip
Feel
Mute
Headphones
Strength
The Amp Clip/Protect LED lights to indicate amplifier clipping and flashes to indicate that the unit has entered its
protection mode.
Feel Control
The BOOM-1 Tactile Transducer Processor offers three distinct options that allow you to tailor the response
of the unit’s DSP processing to the incoming audio and allow you to choose the most musical setting
based on your own tastes. The easy-to-use
F
eeL
control steps through three preset DSP settings from
t
IgHt
to
L
ooSe
that control numerous parameters including the internal filtering cutoffs, compression
threshold and compression ratio values. Simply press the momentary button to choose a preset.
Setting
Description
3 LEDs
Loose
— Highest compression threshold; allows more
dynamic variations from soft to loud.
Highest filter cutoff frequency, allows the most source
audio to reach the DSP input.
2 LEDs
Medium
— Average compression threshold;
The filter cutoff frequency is set higher than the Tight
setting, allowing more low frequency information from
drums, bass, and guitars, etc., to be sent to the tactile
transducer.
1 LED
Tight
— Lowest compression threshold; allows fewer
dynamic variations from soft to loud.
Lowest filter cutoff frequency emphasizes kick drum and
bass.
