1. Removing the AI NVR Cover
1. Shut down the AI NVR. Press the power button on the front panel, and wait for the light to stop blinking
to indicate shutdown is complete.
2. Remove all network, power and peripheral cables from the AI NVR.
3. At the top of the AI NVR, unlock the latch release then lift and rotate the latch towards the back of the
unit. The cover slides back and is released from the body.
Tip:
Use a Phillips #2 screwdriver to remove the shipping screws before unlatching the cover
if you are removing the cover of an AI NVR for the first time.
4. Remove the air shroud by holding it at both ends and lifting it away from the system.
5. Remove the black plastic protective cover over the socket. Press the 2 blue clips and lift off the cover.
The protective cover is no longer needed and can be recycled.
6. View the interior of the AI NVR and identify the locations where the components of the kit will be
installed.
The view below shows the details of an AI NVR with all of the covers and cards removed, and
important components labeled with numbers.
Important:
The view below does not show the GPU card that is pre-installed in Expansion
1. Removing the AI NVR Cover
6
