Manage Time Settings
Customize how the ACC ES Rugged 8-Port Appliance keeps time:
1. Select your
Time Zone
from the drop-down list. The time zone that you set here is used by the
recording schedules defined in the ACC Client software.
2. Select whether you want to keep synchronized time through a Network Time Protocol (NTP) server
(recommended) in the NTP field.
Tip:
To synchronize time with ONVIF devices (that is, non-Avigilon cameras), you can connect
to port 123 on the ACC ES Rugged 8-Port Appliance to use it as an NTP server.
Select:
l
DHCP
to automatically use the existing NTP servers in the network.
l
Manual
to enter the address of NTP servers in the Servers list. Controls to add and delete
addresses in the list, and reorder them are activated.
l
Off
if you do not use an NTP server.
Note:
The default set of NTP servers is always present in the Servers list. However, this list is
only used if NTP is enabled and not provided by your DHCP server. The default list cannot
be rearranged or deleted.
l
0.pool.ntp.org
l
1.pool.ntp.org
l
2.pool.ntp.org
l
3.pool.ntp.org
3. Click
Apply
to save the time settings.
Monitoring and Disconnecting the Storage SSD
On the
Storage
panel of the ACC ES Rugged 8-Port Appliance you can:
l
View the storage capacity and the status of the replaceable storage sold-state drive (SSD).
l
Set the status of the storage SSD to Offline before to removing it from the appliance for replacement
if it ever fails.
Important:
The storage SSD must be replaced with an SSD of the same capacity (2TB for the
VMA-RPA-8P2 model, or 4TB for the VMA-RPA-8P4 model.
Click
Storage
on the navigation bar to open the Storage panel. You can perform any of the following actions
Manage Time Settings
21
