Avidyne Entegra EX5000, Руководство по установке

Страница: 73 / 114

EX5000 Release 8.2.2 Installation Manual P/N 600-00073-001 Rev 02
- 73 -
Sky Trax 100/100B, FDL-978-RX, NGT-9000, GTX-345 Weather selection on Aircraft Setup Page
2.
Set the options that appear on the Aircraft Setup Page. These options will vary depending on the
aircraft model and optional features selected.
3. When you are done, press Save . Press Cancel to exit without saving changes.
4.
Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press
Restart System .
5.12.1 Auxiliary Data Setup
On some aircraft, you can optionally configure the MFD to receive pressure altitude and outside air
data (OAT) from the PFD via a ARINC 429 interface.
If Aux Data is available, configure it as follows:
•
Aux Data —Select Entegra PFD. This allows the MFD to receive ARINC 429 data from the PFD
for input to the % Power calculations.
•
Port— Select the MFD ARINC port to which the PFD is wired.
Auxiliary Data Checkout
After the MFD has been restarted, any of the following messages may appear in the message bar on
any page and in the message list on the Setup page.
Table 24: Auxiliary Data Messages
Message Meaning
PFD is Operating Normally Verifies that pressure altitude and OAT data received by the MFD is valid.
PFD is Not Communicating Pressure altitude or OAT data are not being received by the MFD.
5.12.2 XM Broadcast Datalink and FIS-B Setup
Note: MLB 700 is no longer supported with software release 8.2.
Configure Broadcast as follows:
Broadcast —XM Radio, SkyTrax 100 Radio, Capstone Radio, or None. This enables the weather
datalink functionality. Do Not Use SkyTrax 100 Radio, Use Capstone Radio instead.
Port— Select the RS-232 port wired to the Broadcast Datalink receiver.
Baud (Applicable only for FIS-B) — Select 38,400 or 115,200.