Avidyne Entegra EX5000, Руководство по установке

Страница: 52 / 114

EX5000 Release 8.2.2 Installation Manual P/N 600-00073-001 Rev 02
- 52 -
5.8.3 SkyTrax 100/100B, FreeFlight FDL-987-RX or NGT-9000 ADS-B
Traffic Setup

To set up the ADS-B Traffic interface of the SkyTrax 100/100B ADS-B Receiver:
1.
From the Maintenance Mode Page, select Traffic Setup. The Traffic Setup Page displays:
Figure 18: SkyTrax 100/100B, FDL-978-RX or NGT-9000 selection on Traffic Setup Page
2. Set the following options:
•
Sensor— ADS-B
•
Port— Select the MFD ARINC 429 port to which the ADS-B Receiver is wired (Port 3 shown
for example)
3.
When you are done, press Save . Press Cancel to exit without saving changes.
4.
Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press
Restart System . If needed, see Table 20: Traffic Messages.
5.8.4 Garmin GTX-345 Traffic Setup

To set up the ADS-B Traffic interface of the Garmin GTX-345 ADS-B Receiver:
1. From the Maintenance Mode Page, select Traffic Setup. The Traffic Setup Page displays:
Figure 19: GTX-345 selection on Traffic Setup Page